[BenQ FAQ] Projector_How to use PJLink – In the same domain

[BenQ FAQ] Projector_How to use PJLink – In the same domain


Makre sure the projector and the computer are connected to the same domain Go to Standby Setting in projector’s OSD menu Select “Network” Enable Network Standby Mode as “On” Go to Network Setting in projector’s OSD menu Select Wired Lan (if the projector is using RJ-45 cable) Make sure DHCP is “On” Must “Apply” to save the settings Apply successfully, waiting for network configuration completed Select source as “Network” and the IP address will be showed Execute PRLink tool on your computer (ex. PJLinkTEST4PJ) Go to Setup Menu and select “Network” Input the IP address of the projector and input Port No. 4352 Click “Get All”, to build up communication between the projector and the computer Ready to control projector by PJLink

Leave a Reply

Your email address will not be published. Required fields are marked *