LumiForge Tutorial 1: projector installation

LumiForge Tutorial 1: projector installation


Lumiforge How to install the projector inside the 3d printer. Mounting the metal plate. Place the provided 3 washers on the corresponding threaded holes on the projector botton part. Now place the metal plate on top so that the 3 small holes corresponds to the projector threaded holes. Now thighten well the provided screws. Fixing the projector. Take the projector vertical with the lamp facing down into the printer, match the botton metal plate with the black projector holder on the right side of the printer. Now screw the provided black knobs into the 2 signed holes. Thighten well so that the projector is totally stable Connecting the projector. Inside the 3d printer you will find a power and a VGA cable. Make sure the VGA cable is passing in between the two vertical rods so it will not interfere with the projector movement. Now connect the blue VGA plug to the corresponding port on the projector and do the same with the power plug. How to extend the projector screen We are show here on windows but according to your operation sistem enter the control panel, look for screen settings, when asked how do you want to use the projector screen choose extend. Installing the servo shutter. Take the provided metal servo shutter and fix the round plastic end to the blue controller below the projector. To open and close the shutter press the two keys on the right simultanously. Make sure that when closing the shutter totaly cover the projector light. If it dosen’t take it out and install it again with some rotation.

Leave a Reply

Your email address will not be published. Required fields are marked *